DSE6120 DSE6120 MKII Replacement Generator Controller Auto Start Module Diesel Genset Control Pannel

Product Introduction

The DSE6110 is an Auto Start Control Module and the DSE6120 is
an Auto Mains (Utility) Failure Control Module suitable for a wide variety of single gen-set applications.
Monitoring speed, frequency,voltage, current, oil pressure, coolant temperature and fuel level, the modules will display warnings, shutdown and engine status information on the back-lit LCD screen and illuminated LED.

Key Features

• Back-lit text LCD display
• Front panel editing
• LED and LCD alarm indication
• Power Save mode
• CAN and Magnetic Pick-up/Alt.versions available (specify on
ordering)
• PC and front panel configuration
• 6 Digital inputs
• 3 Analogue inputs
• 6 Outputs (4 configurable on Magnetic Pick-up/Alt., 6
configurable on CAN version)
• Configurable timers and alarms
• Alternative configuration
• Event Log (10)
• Remote Start input
• 3 Phase generator monitoring
• Current Monitoring and protection • 3 Phase Mains (Utility) monitoring
(DSE6120 only)
• Test button (DSE6120 only)
• Battery voltage monitoring
• Engine pre-heat
• Hours counter
• Comprehensive shutdown or warning on fault condition

Specification

CONTINUOUS VOLTAGE RATING：8 to 35 Vdc Continuous

CRANKING DROPOUTS：Able to survive 0 V for 50 mS, providing supply was at least 10 V before dropout and supply recovers to 5 V. This is achieved without the need for internal batteries.LEDs and backlight will not be maintained during cranking.

MAXIMUM OPERATING CURRENT： 178 mA at 12 V, 95 mA at 24 V

MAXIMUM STANDBY CURRENT：88 mA at 12 V, 50 mA at 24 V

MAINS (UTILITY) DSE6120 ONLY
VOLTAGE RANGE：15 V - 333 V AC (L-N)

FREQUENCY RANGE：3.5 Hz to 75 Hz

WORKING TEMPERATURE RANGE：-40 oC to +85 oC